Dewalt DWS7085 Instruction Manual - Page 4

English 1. Remove the two screws from the miter saw handle with the T20 wrench provided. Save the screws to install the Worklight Power Supply (WPS) in Step 4. Retain the handle cover for future use if WPS is removed. 2. Attach the connections to the WPS. 3. Arrange the wire connection such that the wide portion of the connector is placed against the bottom of the miter saw handle and fit the WPS to the handle. making any adjustments or removing/installing attachments or accessories. WARNING: To reduce the risk of serious personal injury, DO NOT operate saw without the cover or worklight in place. WARNING: To reduce the risk of serious personal injury, DO NOT touch the sharp points on the blade with fingers or hands when guard is open. 1. Remove the four screws (A) with the the T20 wrench provided. Save the screws to install the worklight in Step 4. Retain the cover for future use if worklight is removed. NOTE: Manually open the guard (B) if needed to access and remove the lower two screws (A). A (upper screw) B B A (lower screw) 4. Attach the WPS with the two screws removed in Step 1. 2. Attach the connection from lead wire to the worklight. INSTALLATION OF THE WORKLIGHT WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before 2