Dewalt DXCMV5248069 Instruction Manual - Page 14

English • Use pipe that is the same size as the air tank outlet. Piping that is too small will restrict the flow of air. • If piping is over 100' (30.5 m) long, use the next larger size. • Bury underground lines below the frost line and avoid pockets where condensation can gather and freeze. Apply pressure before underground lines are covered to make sure all pipe joints are free of leaks. • A flexible coupling is recommended to be installed between the globe valve/air discharge outlet and main air distribution line to allow for vibration. • A separate regulator is recommended to control the air pressure. Air pressure from the tank is usually too high for individual air driven tools. • DO NOT install lubricators between the tank and any spray equipment, air tool or accessory requiring oil-free filtered air. • Drain all traps, filters and dirt legs daily. AIR FLOW FEEDER LINES SLOPE WITH AIR FLOW AIR FLOW MAIN DISTRIBUTION AIR LINES Slope pipe in direction of air flow. Water condensate flows along bottom of pipe to drain legs, preventing it from entering feeder lines. AIR USAGE LINES .01 MICRON 5 MICRON FILTER FILTER FILTER / MOISTURE TRAP DRAIN LEGS DRAIN VALVES SPRAY GUN REGULATOR BALL FILTER DIRT LEGS DRAIN VALVES FILTER / MOISTURE TRAP FOR BEST PERFORMANCE the distance between the compressor and the moisture trap should be as long as possible FLEXIBLE COUPLING DRAIN VALVE TYPICAL COMPRESSED AIR DISTRIBUTION SYSTEM RISK OF BURSTING. ALWAYS USE METAL PIPING AND FITTINGS. REGULATOR LUBRICATOR AIR TOOL AIR COMPRESSOR GLOBE VALVE / AIR DISCHARGE VALVE DRAIN VALVE How to Use Your Unit (Fig 3) How to Stop: Set the Auto/Off switch to "Off". Before Starting WARNING: Do not operate this unit until you read this instruction 14