Dynex DX-24L150A11 User Manual (English) - Page 15

12 DX-24L150A11 Turning on your TV for the first time Turning on your TV for the first time To configure your TV: 1 Make sure that you have inserted the batteries in the remote control, connected your devices to the TV, and connected the AC power. 2 Press (Power), then wait several seconds. The initial Setup Wizard screen opens (only the first time you turn on your TV). 9 Press or to select Home Mode or Retail Mode, then press ENTER. If you select Home Mode, the Choose your TV source screen opens. -OR- If you select Retail Mode, a message stating "Are you sure you want Retail mode? Since in this mode Energy saving is not realized." appears. Select Yes to proceed or No to exit. 3 Press or to select the menu language you want, then press ENTER. The Time screen opens. 4 Press or to highlight Time Zone, then press or to select your time zone. You can select Pacific, Alaska, Hawaii, Atlantic, Eastern, Central, or Mountain. 5 If your viewing area observes daylight savings time, press or to highlight DST, then press or to select On. 6 Press or to highlight Mode, then press or to select Manual (to set the date/time manually), or Auto (the date/time are automatically set by the TV signal source, based on the time zone you selected). 7 If you select Manual mode, make the settings as follows: • Press or to highlight Year, Month, or Day, then press or to adjust the setting. • Set the time by pressing or to highlight Time, then press or to highlight the hour, minute, or AM/PM field. Press or to adjust the setting. 8 Press ENTER. The Choose your Picture Mode screen opens. 10 Press or to select Antenna, Cable, or Cable/Satellite Box, depending on the type of connection you have. • If you are using an antenna for a standard or HD TV signal, select Antenna. • If your cable is connected directly to the TV (without a tuner box), select Cable. • If your cable is connected to your TV through a tuner box, select Cable/Satellite Box. 11 Press when you have made your selection. The channel scan screen opens. If you selected Antenna or Cable, your TV automatically scans for available channels in your area and stores the channel information in the channel list. This may take several minutes. While scanning, the TV displays a progress report. - OR - If you selected Cable/Satellite Box, the auto scan is not necessary and the screen will ask you to select the correct input source for your set top box. Press EXIT to close the menu. Notes: • During auto scan, digital programs will be scanned first, then analog programs. When all available digital programs have been searched, the screen will ask you to "Press MENU or EXIT if you don't need analog channel scan." At this point you can press EXIT to exit the analog channel scan, or just ignore it and the TV will go on scanning. • Channel scan can take up to 30+ minutes. You can press EXIT at any time to stop the auto scan, but you will need to run the auto scan again to create a channel list. 12 Select the corresponding video input source through the INPUT SOURCE menu.