E-Z-GO Express L4 - Gas Owner Manual - Page 47

Volt Power Outlet, Terrain, Modifications To Vehicle, Load Bed

Page 47 highlights

OPERATING PROCEDURES Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. 12 VOLT POWER OUTLET Overuse of accessories may drain the battery and leave insufficient reserve to start the vehicle. A 12 volt power outlet, rated at 15 amps, is located left side of the key/light switch OFF ON F E FUEL 4 12V Power Outlet 12 Volt Power Outlet TERRAIN not on public highways). The vehicle may also be used on established trails or open terrain that is free from stumps, large rocks or holes. The vehicle should not be used to cross water. MODIFICATIONS TO VEHICLE Changes to the weight distribution or the center of gravity may make vehicle unstable or prone to roll over which could result in severe injury or death to the operator or passengers. Do not modify the vehicle in any manner that will change the weight distribution of the vehicle. Changes to the weight distribution or the center of gravity may make it unstable or prone to roll over which could result in severe injury or death to the operator or passengers. LOAD BED To reduce the possibility of severe injury or death, read, understand and follow the Warning label affixed to the front of the load bed. An electric lift bed is the standard bed for the ST 400. Lower capacity vehicles have a manual dump feature. A load bed warning label is affixed to the front of the bed. See Appendix A. For safe operation of the vehicle, this label must be understood. See the load bed warning label for maximum load. The load must be positioned in the bed as far forward as possible, distributed in such a way that its center of gravity must not be higher than height noted on label, and secured. Failure to follow these instructions may result in severe injury, damage the vehicle and/or cause the vehicle to tip over. Use extra care when operating loaded vehicle. 4- 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86

4 -
9
OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
4
12 VOLT POWER OUTLET
Overuse of accessories may drain the battery and leave insufficient reserve to start the vehicle.
A 12 volt power outlet, rated at 15 amps, is located left side of the key/light switch
12 Volt Power Outlet
TERRAIN
not on public highways). The vehicle may also be used on established trails or open terrain that is free from
stumps, large rocks or holes. The vehicle should not be used to cross water.
MODIFICATIONS TO VEHICLE
Changes to the weight distribution or the center of gravity may make vehicle unstable or prone to
roll over which could result in severe injury or death to the operator or passengers.
Do not modify the vehicle in any manner that will change the weight distribution of the vehicle. Changes to the weight
distribution or the center of gravity may make it unstable or prone to roll over which could result in severe injury or death
to the operator or passengers.
LOAD BED
To reduce the possibility of severe injury or death, read, understand and follow the Warning label
affixed to the front of the load bed. An electric lift bed is the standard bed for the ST 400. Lower
capacity vehicles have a manual dump feature. A load bed warning label is affixed to the front of
the bed. See Appendix A. For safe operation of the vehicle, this label must be understood. See the
load bed warning label for maximum load. The load must be positioned in the bed as far forward as
possible, distributed in such a way that its center of gravity must not be higher than height noted on
label, and secured. Failure to follow these instructions may result in severe injury, damage the
vehicle and/or cause the vehicle to tip over. Use extra care when operating loaded vehicle.
12V Power
Outlet
ON
OFF
FUEL
F
E