E-Z-GO Express L6 - Electric Owner Manual - Page 46

OPERATING PROCEDURES Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. NOTICE Looping the DC cord through the steering wheel when charging serves as a good reminder to store the cord out of the way when finished with charging. The DC plug can be damaged by driving over or catching the cord on the vehicle when driving away. To reduce the possibility of a physical hazard that could result in an electrical shock or electrocution, be sure that the charger plug is not damaged and is inserted into a grounded receptacle. 4 The power (AC) cord is equipped with a grounded plug, do not attempt to pull out, cut or bend the ground post. The charging (DC) cord is equipped with a polarized connector which fits into a matching receptacle on the vehicle. On-board Charger The on-board charger is located at the rear of the vehicle and is mounted between the frame rails. An optional retractable AC cord reel is also available. The charger is wired directly to the batteries, only requiring it be plugged into a dedicated 15 amp AC outlet to be operational. When charging cycle is complete, replace cord around charger handle in area provided or in the retractable cord reel (if equipped). NOTICE If vehicle is to be charged with a non E-Z-GO charger, refer to the instructions supplied with the charger. Battery Charger Retractable AC Cord Reel Frame Rail Front of Vehicle On-board charger NOTICE Looping the DC cord through the steering wheel when charging serves as a good reminder to store the cord out of the way when finished with charging. The DC plug can be damaged by driving over or catching the cord on the vehicle when driving away. An ungrounded electrical device may become a physical hazard that could result in an electrical shock or electrocution. 4- 4