E-Z-GO Express S6 - Electric Owner Manual - Page 60
Fuse Replacement, Transporting Vehicle, Service And Maintenance
View all E-Z-GO Express S6 - Electric manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
MAINTENANCE Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers. FUSE REPLACEMENT To replace fuses, locate the fuse block under the driver side seat. Pull out old fuse and replace with a new automotive type fuse. Headlight and taillight bulbs and fuses are available from a local Distributor, an authorized Branch or the Service Parts Department. TRANSPORTING VEHICLE Towing 5 This vehicle is not designed to be towed. It is recommended that the vehicle be moved by placing the entire vehicle on a trailer, flatbed truck or other suitable transport. Hauling To reduce the possibility of severe injury or death while transporting the vehicle: Secure the vehicle and contents. Never ride on the vehicle being transported. Always remove the windshield before transporting. Maximum speed with sun top installed is 50 mph (80 kph). If the vehicle is to be transported at highway speeds, the sun top must be removed and the seat bottom secured. When transporting vehicle below highway speeds, check for tightness of hardware and cracks in sun top at mounting points. Always remove windshield when transporting. Always check that the vehicle and contents are adequately secured before transporting. The rated capacity of the trailer or truck must exceed the weight of the vehicle (see GENERAL SPECIFICATIONS for vehicle weight) and load plus 1200 lbs. (544 kg). Secure the vehicle using ratchet tie downs. SERVICE AND MAINTENANCE To reduce the possibility of severe injury or death from improper servicing techniques: DO NOT attempt any type of servicing operations before reading all notes, cautions and warnings in this manual. Any servicing requiring adjustments to be made to the powertrain while the motor is running must be made with both drive wheels raised and vehicle properly supported on jack stands. To reduce the possibility of motor damage, never operate vehicle at full throttle for more than 4 - 5 seconds while vehicle is in a 'no load' condition. Reduce the possibility of accidental starting by disconnecting battery at negative terminal before servicing. 5- 8