EdgeStar AP14000W Owner's Manual - Page 19

Fan Only Mode Fan Only mode is used to circulate the air in your room. No temperature setting is needed. NOTE: Fan Only mode does not require that the exhaust hose be attached. To operate the unit in Fan Only mode: 1) Make sure the power cord is plugged into a power outlet. 2) Press the Power button on the remote control. 3) Press the selected. Mode button until the Fan Only indicator is 4) Press the Speed button to select the fan speed. You can choose between Low, Medium and High speed. Heat Mode (HS Model Only) The AP14000HS model portable air conditioner can work as a heat pump. It must be vented for it to expel the cold air out the exhaust. NOTE: The exhaust hose must be used in Heating Mode To operate the unit in heat mode: 1) Make sure the power cord is plugged into a power outlet. 2) Press the Power button on the remote control. 3) Press the selected. Mode button until the Heat indicator is 4) Select the fan speed by using the Speed button. 5) Change the set temperature by using the Up and Down buttons. The temperature is adjustable between 61°F - 80°F in one degree increments. You can switch between Fahrenheit and Celsius by pressing the button. Fan Speed The Fan Speed button is used to change the fan speed while in Cooling, Fan Only and Heating (HS Model only) modes. Press the Fan Speed button to select the fan speed. You can choose between Low, Medium and High speed. Note: Although the remote control will allow you to set the fan speed in Dehumidify mode, the unit will not actually change the fan speed. EdgeStar Portable Air Conditioner 16