EdgeStar AP14000W Owner's Manual - Page 7

Preparations for installing the window kit Window Kit Installation Instructions You must vent your portable air conditioner when running in it cooling mode and heating mode (HS model). Your unit includes a window exhaust kit that can be used to vent the unit out a window. Before you begin, make sure you have all the parts necessary for installation. Window Kit Parts List: NOTE: Exhaust Covers may be attached to the Grated Adapters. You may need to twist and pull apart to separate them. 8 Screws 2 Exhaust Hoses 2 Grated Adapters 2 Exhaust Covers NOTE: You may need to contact your electrician if your room's circuit is not able to power your unit. 1 Window Kit Plate with Holes 4 Duct Connectors 2 Window Kit Plates If you have multiple windows, choose one that is near an electrical outlet that will be able to provide sufficient power to your unit. See the power requirements listed on the product label printed on the side, or on the back of your portable air conditioner. Your window kit can be installed on a horizontal or vertical sliding window as shown in the following pictures: Follow the instructions on the next pages to install the window kit. Note: This unit can be used with one or two vent hoses. The exhaust hose should always be used in cooling and heating (HS model) mode. The air intake hose can be used to increase the cooling efficiency of the unit. If the air intake hose is not used, simply cover one of the grated adapters on the window kit with a vent cap. EdgeStar Portable Air Conditioner 4