EdgeStar AP16000G Owner s Manual - Page 20

Maintenance Clean the air conditioner and filters regularly to maximize performance and efficiency, and prolong the unit's life. Be sure to always unplug the air conditioner from the power outlet before cleaning. Cleaning the unit Use a soft dry cloth to wipe the body clean. If necessary, use lukewarm water to dampen a cloth to clean the unit. Use a soft bristle brush to clean between the vents. Carefully use a vacuum cleaner to clean the condenser coils. Never use abrasive chemicals, volatile substances, gasoline, detergents, chemically treated cloths, or other cleaning solvents that may damage the cabinet exterior. Never spray water directly on the unit. Cleaning the pre-filter NOTE: Filters should be replaced every 2-3 months or as needed. Contact EdgeStar retailers for replacement filters. To clean the pre-filter, follow the steps below: 1) Power off the unit and remove the pre-filter. 2) Remove the activated carbon filter. 3) Use a vacuum cleaner or tap the filter lightly to remove loose dust and dirt, then rinse thoroughly under lukewarm running water (below 104°F). You may use a mild soap and water solution if needed. Allow the pre-filter to air dry in a cool and shaded place. Dry thoroughly before reinstalling. Clean the pre-filter periodically. If the unit is used in a dusty environment you may need to clean it on a weekly basis. Warning: Never operate the unit without the pre-filter. Preparation for Storage If you are not going to be using the unit for an extended period of time, follow the instructions below before storing your unit: 1) Drain all the water from the unit's reservoir. Operate the unit in fan mode for a few hours to thoroughly dry any moisture left on the coils inside the unit. 2) Power off the unit, and clean or change the filters. 3) Unplug and carefully wind the power cord. 4) Remove the exhaust hose and duct connectors and keep them in a safe place. Edgestar Portable Air Conditioner 16