EdgeStar CWD1550S Owner s Manual - Page 13

NOTE: There may be residual moisture in the drum of your new combo washer/dryer. EdgeStar runs every unit through a series of performance tests during the quality control process. Connect supply lines / inlet hoses to machine Connect both water inlet hoses to the back of the Combo Washer/Dryer as indicated in the figure below. The hot and cold water input ports are color coded, red for hot and blue for cold. Use adjustable pliers to tighten firmly. Connect supply lines / inlet hoses to water supply Connect each of the water inlet hoses to the corresponding water supply valve (hot or cold) and tighten securely by turning the connector clockwise. Use adjustable pliers to tighten firmly. IMPORTANT: Check for leaks! Open both water supply valves and ensure that all 4 connections are sealed tightly. If not, close the supply valves and repeat the steps to connect inlet hoses and ensure that you have threaded the hose connections properly. Once you are satisfied that the hoses have been connected properly, please close both water supply valves and continue the installation process. NOTE: This appliance will heat water to the appropriate temperature if a hot water source is unavailable. Increased energy consumption will occur. EdgeStar Combo Washer/Dryer 8