Edimax EW-7415PDn Manual - Page 11

II: System and Network Setup

Get Edimax EW-7415PDn PDF manuals and user guides View all Edimax EW-7415PDn manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Chapter II: System and Network Setup 2-1 Installing the access point to your Network Please follow the following instruction to build the network connection between your new wireless access point and your computers, network devices: 1. Connect the access point to ADSL modem, router, or switch/hub in your network through the LAN port of the access point by Ethernet cable. 2. Connect the A/C power adapter to the wall socket, and then connect it to the 'Power' socket of the access point. 3. Please check all LEDs on the front panel. 'PWR' LED should be steadily on, LAN LEDs should be on if the access point is correctly connected to the ADSL modem, router or switch/hub. If PWR LED is not on, or any LED you expected is not on, please recheck the cabling, or jump to '4-2 Troubleshooting' for possible reasons and solution. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
5
Chapter II: System and Network Setup
2-1 Installing the access point to your Network
Please follow the following instruction to build the network connection between your new
wireless access point and your computers, network devices:
1.
Connect the access point to ADSL modem, router, or switch/hub in your network through
the LAN port of the access point by Ethernet cable.
2.
Connect the A/C power adapter to the wall socket, and then connect it to the ‘Power’
socket of the access point.
3.
Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, LAN LEDs
should be on if the access point is correctly connected to the ADSL modem, router or
switch/hub. If PWR LED is not on, or any LED you expected is not on, please recheck
the cabling, or jump to
‘4-2 Troubleshooting’
for possible reasons and solution.