Electrolux E23BC69SPS Complete Owners Guide English - Page 13

Removing the Doors 13 To reinstall the refrigerator doors: IMPORTANT When replacing the doors on the lower hinge, they must be installed at a 90 degree angle. 1 Replace the lower hinge screws. 2 Holding the door at a 90 degree angle, drop the pin down into the center hinge opening. Rotate it slightly in either direction until the door falls down into place. Pin Mechanism (Door Bottom) Bottom Hinge Opening Doors at 90º 3 Reinstall top hinge. 4 Insert the water line in the top left tunnel pushing from the front to the back of the unit. NOTE Upon replacement, the tube needs to be fully inserted up to the marking line. 5 Reconnect the harnesses. 6 Replace the top hinge covers. 7 Reconnect electrical power cord to the wall outlet. To reset door pin: If doors are removed at less than a 40 degree angle, the pin returns to the home position. It can be reset by turning the door upside and using a 5/32" Allen wrench to rotate the left hand pin 90 degrees clockwise and the right hand pin 90 degrees counterclockwise. Bottom of the Doors For RIGHT DOOR, turn pin 90˚ counterclockwise For LEFT DOOR, turn pin 90˚ clockwise Insert tube up to the marking line Press Press Water Line Water Line Once the door pins are reset, follow the steps "To reinstall the refrigerator doors". NOTE When reinserting the water tube and replacing the top hinge cover, use care to be sure you do not kink the tube.