Electrolux E23CS78HP Use and Care Guide - Page 13

Controls & Settings What To Do if The Temperature Displays Flash If ever you see both temperature displays continuously flashing, it may indicate that the control system has detected a performance problem. Call your Electrolux service representative, who can interpret the flashing message. Turning The Cooling System On And Off You can disable the cooling system in your refrigerator by pressing the On/Off button located on the left side of the temperature control panel. To ensure that you do not accidentally turn off the cooling system, the button does not work unless you press and hold it for three seconds. Once you disable the cooling system, all refrigeration to the freezer and fresh food compartments stops. Coohng System On/Off Button To turn the cooling system back on, you must again press and hold the On/Off button for three more seconds. Responding to Alarms (Audible Tones & Indicator Lights) Your refrigerator's control system can convey the following information through audible tones and the alarm indicator lights. Alaim Name. On On Door Ajar High Temp Powe r Failure IndicatOr' Light (light is off) Steady Green FGlarseheinng FAlamshbienrg Flashing Amber Audible' Condition' Tones Alarm system is not active while Freezer and Fresh Food compartments are cooling toward the current temperature settings. Alarm system is active. How to Respond If Freezer and Fresh Food compartments do not match your temperature settings in three hours, expect the control system to signal other conditions. If cooling down not stabilize toward your current settings, call 1-877-435-3267 for assistance. No response required. Freezer or Fresh Food door has been open for over five minutes. Freezer or Fresh Food compartment has been too warm (45°F or higher) for over an hour. A power outage was detected. Close door to disable and reset alarm. Press Alarm Reset button to turn off alarm. If temperatures do not improve call 1-877-435-3267 for assistance. Press Alarm Reset button to turn off alarm and again to reset. Check if the power failure lasted long enough to affect stored food temperatures.