Electrolux E23CS78HP Use and Care Guide - Page 8

Removing The Doors 4 Remove the plastic closer and pin from the lower hinge assembly. 3 Detach the water tube from the connector located below the freezer door. The connector releases when you press its outer sleeve inward. To remove the freezer door: 1 Detach the multi-wire cable connector located above the top hinge. Grasp both sides of the connector firmly and pull apart. 4 Remove the screws from the top hinge and pull the multi-wire cable through it. Lift the door off of the bottom hinge. Trace lightly around the hinge with a pencil. This makes reinstallation easier. Lay the door on its side to avoid damage to the water tube extending from the bottom hinge. Remove the plastic closer and pin from the lower hinge assembly. 7 Remove the two bottom hinge screws and hinge if necessary. To reinstall the freezer door, reverse the above steps. Once both doors are in place, ensure they are aligned with each other and level (Please see To level the doors using the lower hinge in Installation section.), then replace the top hinge cover.