Electrolux E30MH65GSS Installation Instructions - Page 15

Installation Instructions B2. USE TOP CABINET TEMPLATE FOR PREPARATION OF TOP CABINET You need to drill holes for the top support screws, a hole large enough for the power cord to fit through, and a cutout large enough for the exhaust adaptor. B3. ADAPTING MICROWAVE BLOWER FOR OUTSIDE TOP EXHAUST 1. Remove and save screw that holds blower plate to microwave. 2. Lift up the blower plate. • Read the instructions on the TOP CABINET TEMPLATE. • Tape it underneath the top cabinet. • Drill the holes, following the instructions on the TOP CABINET TEMPLATE. CAUTION: Wear safety goggles when drilling holes in the cabinet bottom. Blower Plate Back of Microwave Screw 3. Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the blower unit. CAUTION: Do not touch blade of blower to prevent cracking and breaking. Hold outer case when the blower is removed and re-installed. 4. Roll the blower unit 90° so that fan blade openings are facing toward the top of the microwave. BEFORE: Fan Blade Openings Facing Forward Roll 15