Electrolux E32AF85PQS Complete Owners Guide English - Page 6

6 Installation Required Tools You will need the following tools: Tools Necessary: Adjustable Wrench Phillips Head or #2 Square Drive Head (OR) and oOrR OR or Socket WrencShoSckeet t Wrench Set Adjustable Wrench 3/8" Fixed Wrench CAUTION DO NOT install the appliance where the temperature will drop below 40°F (13°C) or rise above 110°F (43°C). The compressor will not be able to maintain proper temperatures inside the unit. DO NOT block the toe grille on the lower front of your appliance. Sufficient air circulation is essential for the proper operation of your unit. Installation • Allow the following clearances for ease of installation, proper air circulation, and plumbing and electrical connections: Sides ⅜" (9.5 mm) Top &Back 1" (25.4 mm) • Allow for trim kit if it to be installed with the unit. This Use & Care Guide provides general installation and operating instructions for your model. We recommend using a service or kitchen contracting professional to install your appliance. Use the unit only as instructed in this Use & Care Guide. Before starting the appliance, follow these important first steps. Location • Choose a place that is near a grounded, non-GFCI, electrical outlet. Do Not use an extension cord or an adapter plug. • If possible, place the unit out of direct sunlight and away from the range, dishwasher, or other heat sources. • The appliance must be installed on a floor that is level and strong enough to support a fully loaded unit. • Consider water supply availability for models equipped with an automatic ice maker. NOTE If your appliance is placed with the door hinge against a wall, you may have to allow additional space so the door can be opened wider. NOTE The appliance doors are designed to shut by themselves within a 20-degree opening. 1" (25 mm) 1" (25 mm) NOTE The exterior walls of the unit may become quite warm as the compressor works to transfer heat from the inside. Temperatures as much as 30ºF warmer than room temperature can be expected. ⅜" (10 mm) ⅜" (10 mm)