Electrolux E32AF85PQS Complete Owners Guide English - Page 7

Installing Door Handle & Leveling 7 Door Handle Mounting Instructions 1. Remove handle from carton and any other protective packaging. 2. Position handle end caps over upper and lower preinstalled shoulder bolts (A) that are fastened into door. 3. While holding handle firmly against door, fasten upper and lower Allen set screws (B) with supplied Allen wrench until there is no gap between handle and door. NOTE All set screws should be tightened so the screw is below the surface of the handle. The handles should be drawn tight to freezer and refrigerator doors with no gaps. Opening the opposite door while tightening the Allen screw makes installation easier. The door handle may loosen over time or if it was installed improperly. If this happens, tighten the set screws on the handles. Toe Grille Removal To remove the toe grille, use a Phillips screwdriver and remove the two screws holding the toe grille to the cabinet. Then pull the toe grille away from the unit. Leveling • The freezer must have all bottom corners resting firmly on a solid floor. • The floor must be strong enough to support a fully loaded freezer. • It is VERY IMPORTANT for your freezer to be level in order to function properly. If the freezer is not leveled during installation, the door may be misaligned and not close or seal properly, causing cooling, frost or moisture problems. Toe Grille Remove Screws