Electrolux E48GC76EPS Installation Instructions

Electrolux E48GC76EPS - 48" Sealed Burner Slide-In Gas Cooktop Manual

Get Electrolux E48GC76EPS - 48inch Sealed Burner Slide-In Gas Cooktop PDF manuals and user guides View all Electrolux E48GC76EPS manuals
Add to My Manuals
Save this manual to your list of manuals

Electrolux E48GC76EPS manual content summary:

  • Electrolux E48GC76EPS | Installation Instructions - Page 1
    Installation Instructions Slide In Gas Cooktop E36GC76EPS E48GC76EPS 5995447108
  • Electrolux E48GC76EPS | Installation Instructions - Page 2
    2 Safety IMPORTANT SAFETY INSTRUCTIONS Safety Precautions Do not attempt to install or operate your unit until you have read the safety precautions in this manual. Safety items throughout this manual are labeled with a Warning or Caution based on the risk type. Definitions This is the safety alert
  • Electrolux E48GC76EPS | Installation Instructions - Page 3
    PRECAUTIONS WARNING • Read all instructions before using the appliance. • Improper installation, adjustment, alteration, service, or maintenance can cause personal injury or property damage. Refer to these instructions and the accompanying Use & Care Manual. For assistance or additional information
  • Electrolux E48GC76EPS | Installation Instructions - Page 4
    of the cooking utensil. • If the information in this manual is not followed exactly, a fire or explosion may result causing appliance. • Installation of this appliance must be performed by a qualified installer, service agency or the gas supplier. Contact the nearest Electrolux Authorized Servicer
  • Electrolux E48GC76EPS | Installation Instructions - Page 5
    safety instructions. This guide will help you anticipate all installation connections. QUESTIONS? For toll-free telephone support in the U.S. and Canada: 1-877- 4ELECTROLUX (1-877-435-3287) For online support and Internet product information: www.electroluxusa.com ©2005 Electrolux Home Products
  • Electrolux E48GC76EPS | Installation Instructions - Page 6
    Instructions 2 Safety Precautions 3 Finding Information 5 Please Read And Save This Guide 5 Questions 5 Table Of Contents 6 Preparing for Installation Conversion 12 Installation 14 Installing the Cooktop 14 Connecting the Gas 14 Gas and Electric Requirements Table 15 Installing the Burner
  • Electrolux E48GC76EPS | Installation Instructions - Page 7
    64mm) from any combustible backsplash material. This will require special cabinet and countertop dimensions. Installations with less than 2 1/2" from the rear of the cooktop to a combustible backsplash must use Electrolux Backsplash models ACCBG096S1 (for E36GC76EPS) or ACCBG0948S1 (for E48GC76EPS).
  • Electrolux E48GC76EPS | Installation Instructions - Page 8
    purposes. • The specified cabinet dimensions must be provided. The cabinet and/or countertop must completely enclose the recessed portion of the countertop. All contact surfaces between the appliance and the countertop must be solid and level. Plan the installation so that the electrical connection
  • Electrolux E48GC76EPS | Installation Instructions - Page 9
    2, 3, 4, 5 and 6). Position the cutout so that minimum clearances are met. Base Cabinet Preparation Top View Countertop Preparation Figure 2 Figure 3 Countertop Cut-out Dimensions (when Cooktop is to be installed with Downdraft Vent Hood 36" model: E36DD75ESS; 48" model: E48DD75SS) Figure 4
  • Electrolux E48GC76EPS | Installation Instructions - Page 10
    10 Preparing for Installation Overall Dimensions - Side Views Clearance to Combustible Rear Wall Overall Dimensions Cutout Dimensions Clearance to Combustible Rear Wall Figure 5 Figure 6 Cooktop Model E48GC76EPS E36GC76EPS Dimensions A B 48" Min. 48" 36" Min. 36" C D 46" 48" 34¾" 36"
  • Electrolux E48GC76EPS | Installation Instructions - Page 11
    installation. In the absence of local codes, this appliance should be installed in accordance with the National Fuel Gas Code ANSI Z223.1/NFPA 54. Be certain that the appliance being installed is correct for the gas service being provided. Refer to the data plate located on the bottom of the cooktop
  • Electrolux E48GC76EPS | Installation Instructions - Page 12
    the cooktop is not installed by a qualified installer or electrician. CAUTION Any additions, changes or conversions required in order for this appliance to satisfactorily meet the application needs must be made by a qualified service technician in accordance with the manufacturer's instructions and
  • Electrolux E48GC76EPS | Installation Instructions - Page 13
    electrician prior to installing the cooktop. • Do not plug the cooktop into Ground Fault Circuit Interrupter (GFCI) receptacles. The cooktop spark ignition module can cause a GFCI to trip. NOTE It is the owner's responsibility to ensure that the electrical connection for this appliance is performed
  • Electrolux E48GC76EPS | Installation Instructions - Page 14
    to permanently seal the cooktop into place, as the unit must be readily removable for service. If such a hardening cooktop by turning the gas shut-off valve to the off position. Leak testing of the appliance shall be conducted according to the manufacturer's instructions. • For LP gas installations
  • Electrolux E48GC76EPS | Installation Instructions - Page 15
    Installation 15 GAS AND ELECTRIC REQUIREMENTS TABLE The required voltage, frequency and amperage ratings are listed on the product data plate outside on the cooktop bottom. The gas and electric requirements are also shown in the table below. Model No. Electrical Total circuit connected
  • Electrolux E48GC76EPS | Installation Instructions - Page 16
    16 Installation INSTALLING THE BURNER COMPONENTS WARNING Never attempt to operate the cooktop with any of the burner porcelain burner cap on top of its corresponding burner ring. Place each grate onto the cooktop, being certain that the rubber feet are positioned in the locating dimples. Figure 7
  • Electrolux E48GC76EPS | Installation Instructions - Page 17
    can result in a fire hazard! • Do not attempt to use this appliance in the event of a power failure. • Do not use an extension cord with this appliance. • Do not install a fuse in the neutral or ground circuit. • Do not ground this appliance to a gas supply pipe or hot water pipe. Plug the three
  • Electrolux E48GC76EPS | Installation Instructions - Page 18
    that the electrical power supply and gas supply are turned on and that all installation steps have been carefully followed. Call a qualified service technician if the cooktop still does not operate properly. • The cooktop and shut-off valve must be disconnected from the gas supply piping during any
  • Electrolux E48GC76EPS | Installation Instructions - Page 19
    supply to the cooktop by opening the gas flame height progressively. Repeat the ignition test for all burners. When installed properly, the flame will be steady and quiet. It will also Manual prior to cooking with this appliance. The Use & Care Manual contains additional important safety, service
  • Electrolux E48GC76EPS | Installation Instructions - Page 20
    1-877-4Electrolux www.electroluxusa.com www.electroluxca.com
  • Electrolux E48GC76EPS | Installation Instructions - Page 21
    Professional series Liquid Petroleum Gas (LPG) Conversion Kit Instructions Cooktop Models: E36GC76EPS, E48GC76EPS Model E36GC76EPS shown WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's instructions and all applicable codes and
  • Electrolux E48GC76EPS | Installation Instructions - Page 22
    ... Before converting to LPG, install the cooktop in the cabinet according to the installation instructions provided. STEP 1 Verify Kit Contents LPG Conversion Kit for Models E36GC76EPS and E48GC76EPS (36 and 48-Inch) Kit Part Number: 700208-1 Part Number Description 65480 LABEL, CONVERSION
  • Electrolux E48GC76EPS | Installation Instructions - Page 23
    Professional Series Cooktop LPG Conversion Kit STEP 3 Prepare Cooktop for Conversion 3-1 If the cooktop is connected to a natural gas supply line, close the gas supply valve. 3-2 Disconnect the cooktop power connector from the electrical outlet. 3-3 Remove the grates from the top. 3-4 Remove all
  • Electrolux E48GC76EPS | Installation Instructions - Page 24
    STEP 4 Convert Regulator to LPG 4-1 Locate the regulator. It is underneath the cooktop, below the right rear burner. 4-2 Remove the regulator cap from the regulator. Make sure that the regulator spring remains in place. 4-3 Remove the spool from
  • Electrolux E48GC76EPS | Installation Instructions - Page 25
    Professional Series Cooktop LPG Conversion Kit STEP 5 Disassemble Cooktop 5-1 Insert the large end of the burner ring removal 5-3 Repeat steps 5-1 and 5-2 for the remaining tool into the top of the left rear burner head.
  • Electrolux E48GC76EPS | Installation Instructions - Page 26
    position. 6-2 Remove all of the burner knobs from the front of the cooktop. 6-3 Insert the flat-blade screwdriver into the valve stem hole for the burner valves. 6-7 Replace the knobs. Burner Location E36GC76EPS (36-Inch) E48GC76EPS (48-Inch) Left Rear 61 61 Left Front 48 48 Right Rear
  • Electrolux E48GC76EPS | Installation Instructions - Page 27
    Professional Series Cooktop LPG Conversion Kit STEP 7 Replace Main Orifices 7-1 Remove the two . 7-6 Repeat steps 7-1 through 7-5 for the remaining burners. Burner Location E36GC76EPS (36-Inch) E48GC76EPS (48-Inch) Left Rear 112 112 Left Front 86 86 Right Rear 86 86 Right Front
  • Electrolux E48GC76EPS | Installation Instructions - Page 28
    inch. Contact the factory if the 8-4 Close the LPG supply valve. Connect the cooktop reading is not within the limits. to the LPG supply line. 8-8 Turn 9. Be sure to match the model number and burner location. The shutter part number appears on its side. 9-2 Thread the air shutter onto the left
  • Electrolux E48GC76EPS | Installation Instructions - Page 29
    Professional Series Cooktop LPG Conversion Kit Burner Location E36GC76EPS (36-Inch) E48GC76EPS (48-Inch) Left Rear HN A-0053-E Front HN A-0053-E HN A-0053-E Table 9-1 Air Shutter Part Numbers Burner Location E36GC76EPS (36-Inch) E48GC76EPS (48-Inch) Left Rear .38/9.7 .39/9.8 Left Front
  • Electrolux E48GC76EPS | Installation Instructions - Page 30
    become dislodged during re-assembly (see Figure 10-1 for the correct igniter orientation). 10-6 Connect the cooktop to the electrical outlet. 10-7 Turn each burner on HIGH, one at a time. Check adjusting the air shutters does not correct the problem. Figure 11-1 Examples of a Normal Flame Page 10
  • Electrolux E48GC76EPS | Installation Instructions - Page 31
    THIS APPLIANCE WAS CONVERTED ON DAY/MONTH/YEAR TO GAS WITH KIT NO. OF (INSTALLER) (COMPANY NAME) WHICH ACCEPTS THE RESPONSIBILITY THAT THIS CONVERSION HAS BEEN PROPERLY MADE Figure 12-1 Conversion Label Burner Ratings and Altitude Considerations The Electrolux Professional Series cooktop is
  • Electrolux E48GC76EPS | Installation Instructions - Page 32
    (X 100 mm) Air Shutter Part No. 81 184 HN A-0053-E 72 135 HN A-0052-E 72 135 HN A-0052-E 81 184 HN A-0053-E 81 194 HN A-0053-E 81 194 HN A-0053-E Model E48GC76EPS (48-Inch) Air Shutter Gap .38/9.6 .09/2.3 .09/2.3 .39/9.9 .37/9.5 .38/9.7 The Electrolux Group USA • 250 Bobby
  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
Installation Instructions
Slide In Gas Cooktop
5995447108
E36GC76EPS
E48GC76EPS