Electrolux E48GC76EPS Installation Instructions - Page 7
Preparing for Installation - dimensions
View all Electrolux E48GC76EPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Preparing for Installation 7 VERIFY PACKAGE CONTENTS • Literature Pack • Bolts/Washers • Burner Grate Pack • Burner Set • Gas Pressure Regulator • Burner Cap Pack • Griddle • Simmer Plate • Wok Stand • Stainless Steel Cleaner • LP Conversion Kit CABINET/COUNTERTOP PREPARATION The installation of this built-in appliance must be completed by a qualified appliance technician or contractor. Proper installation is the owner's responsibility. Carefully check the location where the cooktop is to be installed. The cooktop should be placed for convenient access, but away from drafts that may be caused by open doors and windows or by HVAC duct outlets. Make certain that gas and electrical power can be provided in the selected locations. Plan the installation so that all minimum clearances are met or exceeded. Dimensions shown provide minimum clearances, unless otherwise noted. WARNING • To reduce the risk of personal injury caused by reaching over a hot appliance, cabinet storage space located directly above the cooktop should be avoided. • Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids. • Failure to provide proper clearances may result in a fire hazard! • Do not store combustible materials or items adversely affected by heat immediately above or below the cooktop. • The back edge of the cooktop must remain a minimum of 2 1/2" (64mm) from any combustible backsplash material. This will require special cabinet and countertop dimensions. Installations with less than 2 1/2" from the rear of the cooktop to a combustible backsplash must use Electrolux Backsplash models ACCBG096S1 (for E36GC76EPS) or ACCBG0948S1 (for E48GC76EPS).