Electrolux EFLW317TIW Installation Instructions English Spanish French - Page 11
Reversing Door
View all Electrolux EFLW317TIW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Reversing Door 11 NOTE Door reversibility is possible only on 500 or 600 series models. IMPORTANT BEFORE YOU REVERSE YOUR WASHER DOOR: 1. Be sure you have adequate swing area before reversing door. 2. Gather your tools - including a screw driver with a #2 square bit and plastic knife (or small, flat prying tool that won't damage paint). 3. Protect flat work surface, such as top of washer or floor near washer, with a soft cloth or towel. 4. Be sure washer is unplugged from power source! WARNING ELECTRICAL SHOCK HAZARD Failure to disconnect power source before servicing could result in personal injury or even death. Tools needed for reversal: Screwdriver with #2 square bit Plastic knife A) Removing Door Assembly 1. Completely open the door to expose all four hinge screws. 2. Remove all four hinge screws with #2 square bit driver. Save for reinstalling later. 4. While supporting the door with one hand, pinch the tabs to release the plastic terminal cap from the hinge plate. x 4 FINE THREAD 3. Grasp the door with both hands -one at the handle area and one at the hinge area. While supporting the door with the hand at the hinge, press firmly with the other hand until the locating pins on the back of the hinge plate dislocate from the front panel. IMPORTANT Take care not to pull the door away from the washer until you remove the wiring harness terminal cap. 5. Set the door face down on a flat surface protected by soft cloth or towel. 6. Release wiring harness from retainer on plastic terminal cap. Then release terminal from terminal cap. Save the cap to reinstall later.