Electrolux EFLW317TIW Installation Instructions English Spanish French - Page 13

Reversing Door Assembly, continued, E Reinstalling Door Assembly, F Verify Reversed Door Operation,

Get Electrolux EFLW317TIW PDF manuals and user guides View all Electrolux EFLW317TIW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

Reversing Door Assembly, continued 3. Make sure the alignment tabs reengage. Reversing Door 13 3. Insert hinge locating pins into the hole that were previously covered by the plastic hole cover. Press on the face of the hinge to snap the other locating pins into place. 4. Reinstall inner door onto outer door with nine screws removed earlier. x 9 4. Reinstall all four screws removed earlier two front screws first, then two side screws. 13 x 4 E) Reinstalling Door Assembly 1. Insert the wiring harness terminal into the terminal cap and wrap the harness into the harness retainer. FINE THREAD 4 2 F) Verify Reversed Door Operation 1. Test door for free, smooth swinging operation and secure latching when closed. 2. Verify inner door glass is in the correct orientation with the "scoop" at the bottom. 2. Slide terminal cap onto back of hinge plate until tabs snap into place. 3. Plug in washer and close the door. Test correct door lock operation by starting a test cycle: lock should engage, and door should not be able to be opened until cycle is paused or canceled.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
13
Reversing Door
x
4
1
2
3
4
x
9
Reversing Door Assembly, continued
3. Make sure the alignment tabs reengage.
E) Reinstalling Door Assembly
1. Insert the wiring harness terminal into the
terminal cap and wrap the harness into
the harness retainer.
F) Verify Reversed Door Operation
1. Test door for free, smooth swinging
operation and secure latching when
closed.
2. Verify inner door glass is in the correct
orientation with the “scoop” at the bottom.
2.
Slide terminal cap onto back of hinge
plate until tabs snap into place.
3. Insert hinge locating pins into the hole
that were previously covered by the
plastic hole cover. Press on the face of
the hinge to snap the other locating pins
into place.
4. Reinstall all four screws removed earlier -
two front screws first, then two side screws.
4. Reinstall inner door onto outer door with
nine screws removed earlier.
FINE
THREAD
3. Plug in washer and close the door. Test
correct door lock operation by starting a
test cycle: lock should engage, and door
should not be able to be opened until
cycle is paused or canceled.