Electrolux EFMG627UTT Complete Owners Guide English - Page 9

Pre-Installation Requirements 9  Installation Checklist Exhaust Venting ˆˆ Free-flowing, clear of lint buildup ˆˆ 4 inch (102 mm) rigid metal or semi-rigid metal transition ducting of minimal length and turns ˆˆ NO foil or plastic venting material ˆˆ Approved vent hood exhausted to outdoors Leveling ˆˆ Dryer is level, side-to-side and front- to-back ˆˆ Cabinet is sitting solid on all corners Gas Supply (Gas Dryer) ToˆolˆsManadnumaal stehruiatolsffnveaelvdeedprfeosreinnst tianllation: supply ˆˆ All connections sealed with approved sealer and wrench tight ˆˆ Conversion kit for LP GAS system ˆˆ Gas supply turned on ˆˆ No leaks present at all connections - check with soapy water, NEVER check with flame 240v Electric Supply (Electric Dryer) ˆˆ Approved NEMA 10-30 or 14-30 service cord with all screws tight on terminal block ˆˆ Approved strain relief installed ˆˆ Terminal access cover installed before initial operation Door Reversal ˆˆ Follow detailed instructions in this guide ˆˆ Test hinge and latch for function Electrical Power ˆˆ House power turned on ˆˆ Dryer plugged in Final Checks ˆˆ Installation Instructions and Use & Care Guide read thoroughly ˆˆ Door latches and drum tumbles when cycle starts ˆˆ Registration card sent in Water Hookup (Select Models) ˆˆ Inspect hoses for proper placement of rubber washers ˆˆ Water supply is turned on ˆˆ Check for leaks ˆˆ Steam model dryers require use of ASSEMBLY HOSE KIT #5304495002 (not included) and must be purchased separately.