Electrolux EI33AF80WS Trim Kit Installation Instructions - Page 12

12 3. a. Fit the first Leveler Assembly onto a refrigerator/freezer (Fig. 3). b. Using a 5H bolt and a power drill, fasten the bottom of the Leveler Assembly with a 3/8" hex drill bit in whichever hole overlaps the screw hole (Fig. 4). Note: The rear of the bracket is contoured to slip over the metal compressor base. Driving the rear bolt first will ensure proper alignment of the lever assembly. c. Using the 4H bolts from step 1, fasten the front of the Leveler Assembly to the refrigerator/freezer using a 5/16" nut driver (Fig. 5). For steps 3b and 3c, if you require more space for nut driver clearance, rotate the bolt labeled F clockwise (Fig. 6) using a flathead screwdriver or a 3/8" socket wrench. Fig. 3 Fig. 4 INSTRUCTION SHEET Trim Kit Center Trim Support 4. With the refrigerator still on its back, use a 5/16" nut driver to remove two 4H bolts and fasten the 10H L-Bar (Fig. 8). Note: The short flange on L-Bar should be facing upward toward the top of the refrigerator. 5. Stand both units upright. Fig. 8 CAUTION The cabinet is heavy. We recommend two people to lift or move the cabinet.. Fig. 5 d. Attach remaining 3 Leveler Assemblies as described in the previous 3 steps using the remaining six 4H bolts and the remaining three 5H bolts. With the unit(s) still on their backs, adjust all leveling wheels to approximately the orientation in Fig. 7. Fig. 6 Fig. 7 ©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21