Electrolux EI33AF80WS Trim Kit Installation Instructions - Page 14
Electrolux TRMKTSS2LV84 Side Trim Attachment Setup
![]() |
View all Electrolux EI33AF80WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 INSTRUCTION SHEET 13. Use the clips provided to hold the excess power cords to the back of the units such that all wires are away from the floor (Fig. 13). NOTE: Make sure the harnesses and cables are cleared off the floor before the units are pushed back in place. This will prevent any damage to the wires. NOTE: The location of clips shown is an example. 14. Plug the power supply into the main outlet before pushing the units into the final position. Trim Kit Tie Bar Installation Fig. 13 IMPORTANT • Before proceeding with trim installation, make sure both refrigerator and freezer are leveled front to back and side to side. • Make sure all 8 wheels are touching the floor. 15. Having the refrigerator/ freezer standing side by side ½" apart, fasten a 9H bracket to the front of the Levelers (Fig. 14), keeping the left-side 8H screws loose. Hand tighten only! NOTE: One side of the bracket is slotted for fine adjustments in step 18c. 16. Attach the other 9H bracket to the rear levelers (Fig. 15), keeping the right screws loose. Hand tighten only! Fig. 14 17. Attach the 1H top tie bar (Fig. 16), keeping the 2 left 4H bolts loose. Fig. 15 NOTE: Before continuing, ensure doors close without interference and remain parallel. Adjusting the height of the wheels can help remedy door alignment issues. Refer to INSTALLATION in the Use & Care Manual to adjust the door height. Fig. 18 NOTE Before proceeding plug in units and verify they are functioning properly. NOTE Some cabinet substrates may require pre-drilling holes using a 1/8" (3 mm) diameter drill bit. Electrolux TRMKTSS2LV84 Side Trim Attachment Setup (some models) 19. Using eight 3H screws and a power drill, attach the two Side Trim Attachment brackets to the front left and right cabinet cut-out edges with the brackets touching the floor (Fig. 19). Ensure the rectangular slots extend over the cabinet edge. 18. a. b. Fig. 16 Open the doors and place the middle trim in between the 2 units. Adjust the proximity of the units as needed to centralize the middle trim. Start by fastening the screws on top 1H bracket in order to evenly space the Center Trim (Fig. 17). Fig. 17 c. Fasten the four 8H screws (Fig. 14 and 15) through 2 front and back 9H brackets. You may need several adjustments for the center trim to be consistently flush and centered to the units. Fig. 19 Side Trim Attachment Setup For: TRMKTEZ2FL75 (Frigidaire) TRMKTEZ2LV79 (Frigidaire) TRMKTEZ2FL79 (Frigidaire) TRMKTSS2FL79 (Electrolux) 20. Depending on which long screw you received (6H or 7H), screw a long screw into the lower left (Fig. 20A) of the A front wall cabinet, close to the location shown in Fig. 20B. 21. Repeat step 20 for the right side of the wall cabinet using the other 6H/7H screw. NOTE: The depth of the screw will vary depending on the cabinet cutout final dimensions. We recommend you leave approximately ½" of screw extending away from the cabinet wall. 0.50 inches B Fig. 20 Fig. 20 ©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21
![](/manual_guide/products/electrolux-ei33af80ws-trim-kit-installation-instructions-042b60d/14.png)