Electrolux EI33AF80WS Trim Kit Installation Instructions - Page 17
Frigidaire TRMKTEZ1FL79 Side Trim Attachment Setup
View all Electrolux EI33AF80WS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
17 INSTRUCTION SHEET Leveling the Unit 4. a. Tilt the unit upright. b. Place the unit into the cabinet space, or as close to the final position as possible (do not hook up power or water yet). This step is important to accurately level the unit prior to further installs. c. Use a flat head screw Fig. 8 driver or a 3/8" socket wrench to adjust the front bolts of the Leveler Assemblies (Fig. 8). Raise or lower the front and back wheels as needed until the unit rests properly in the cabinet space. d. Once the Leveler Assemblies have been checked, roll out the unit in front of the cabinetry for accessibility. NOTE Some cabinet substrates may require pre-drilling holes using a 1/8" (3 mm) diameter drill bit. Electrolux TRMKTSS1LV84 Side Trim Attachment Setup 5. Using eight 3H screws and a power drill, attach the 2 Side Trim Attachment brackets to the front left and right cabinet cutout edges with the brackets touching the floor (Fig. 9). Ensure the rectangular slots extend over the cabinet edge. Fig. 8 Frigidaire TRMKTEZ1FL79 Side Trim Attachment Setup 6. Depending on which long screw you received (6H or 7H) screw a long screw in the lower left area (Fig. 9A) of the front cabinet space, approximately in the location described in Fig. 9B. 7. Repeat step 6 for the right side of the cabinet using the other 6H/7H screw. A 0.50 inches B Power and Water Line Connection Note: Refer to the Use & Care Manual for power requirements and water supply hookup before proceeding. Find Service Kit TTFLTRICEKIT at ElectroluxAppliances.com for connecting the water line and filtering ice. Top Trim Attachment NOTE You will need a step ladder to install top trim components. 8. a. Remove the front outer screw from the top hinge (Fig. 10) using a 5/16" socket driver or wrench and save for later. Locate bracket 1H and place it on the top of the unit to be used on Step 8d. b. Roll the unit into the cabinet roughly ¾ of the way in, ensuring the product is centered in the cabinet cutout. c. Choose the top trim according to which side the door hinge is on (Fig. 11). You do not need the other Top Trim for the installation. d. Install the Top Trim by fastening two 4H screws along the base of the trim with a 5/16" socket wrench (Fig. 12). Screw through the 1H bracket in step 8a to properly level the Top Trim. 1H Fig. 10 Fig. 11 9. a. Slide the unit into place, and ensure the dual installation is centered. b. Drill 1/8" pilot holes and fasten two 3H screws on the right side of the Top Trim with a Phillips screwdriver to cabinets (Fig. 13). c. Repeat for the left side. Fig. 12 Fig. 13 Fig. 20 Fig. 9 ©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21