Electrolux EI33AR80WS Trim Kit Installation Instructions English - Page 13

13 INSTRUCTION SHEET Pairing Kit Installation Before cleaning your appliance, turn off power to your appliance by unplugging the power cord from the electrical outlet. Wipe down both sides of the refrigerator and the freezer.  NOTE Never use CHLORIDE to clean stainless steel. Clean stainless-steel front and handles with non-abrasive soapy water and a dishcloth. Rinse with clean water and a soft cloth. Wipe stubborn spots with an ammoniasoaked paper towel, and rinse. Use a non-abrasive stainless-steel cleaner, such as Frigidaire ReadyClean™ Stainless Steel Cleaner found on Frigidaire.com. Always follow the manufacturer's instruction.  NOTE Always, clean, wipe and dry with the grain to prevent scratching. Wash the rest of the cabinet with warm water and mild liquid detergent. Rinse well and wipe dry with a clean soft cloth. NOTE: For the best results, please use the configurations of the heaters mentioned (Freezer- top right side and Refrigerator bottom left side). Avoid: • Both heaters on the Freezer • Both heaters on the Refrigerator • Both heaters on the top • Both heaters on the bottom • Both heaters in the center 10. Plug in the connector of the two Heaters A into the Power Supply C (Fig. 10). NOTE: You cannot feel the heater temperature as the pads barely heat up. CAUTION Use gloves for the next step. NOTE: Before removing the paper backing, align the heaters to ensure the wires exit toward the center and rear of refrigerator/freezer (as shown in Fig 9). 6. Peel off the paper backing from the first heater. 7. Adhere the first heater to the lower right side of the left-side unit (0.5" from the bottom and 0.5" from the back wall) so the harnesses come out at the top. NOTE: Make sure you adhere the heater completely with no 0.5" air pockets (Fig. 9A). 8. Peel off the paper backing from the second heater. 9. Adhere the second heater to the upper left side of the right- side unit (0.5" from the top and 0.5" from the back wall) so the harnesses come out at the bottom. A 0.5" B NOTE: Make sure you adhere the heater completely with no air pockets (Fig. 9B). For better adhesion remove the yellow label on the side of the cabinet. Fig. 9 NOTE: Confirm the power supply fits into the cutout when placed on top of the unit. Also confirm the power supply reaches the power outlet when placed on top of the unit (Fig. 11A). The extra wire length is provided to accommodate receptacle location. 11. Apply the 2 strips of double- sided tape to the power supply and adhere the power supply on top of the unit (Fig. 11B). 12. If the power supply cannot be placed on top of the unit, adhere it vertically on the back wall of the unit and make sure the connection of the 3-prong connector to the power supply is facing down (Fig. 12). C B A Fig. 10 B A Fig. 11 Fig. 12 ©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21