Electrolux EI33AR80WS Trim Kit Installation Instructions English - Page 15

15 Top Trim Attachment  NOTE You will need a step ladder to install top trim components. 22. a. b. c. 23. a. b. c. Remove the front outer hinge screws, common on both sides of the dual installation, as well as the front two 4H screws that fasten the 1H Tie Bar (Fig. 21). Roll the dual installation into the cabinet, roughly ¾ of the way in, ensuring the product is centered in the cabinet cutout. Install the top trim by fastening four 4H screws along the base of the trim with a 5/16" socket wrench (Fig. 22). Slide the dual installation into place, and make sure it is center inside the cabinets. Drill 1/8" pilot holes and fasten two 3H screws on the right side of the Top Trim (one screw per side for Collared top trim) with a Phillips screwdriver to the cabinets (Fig. 23). Repeat for the left side. Fig. 21 Fig. 22 Fig. 23 Side Trim Installation For: TRMKTEZ2FL75 (Frigidaire) TRMKTEZ2LV79 (Frigidaire) TRMKTEZ2FL79 (Frigidaire) TRMKTSS2FL79 (Electrolux) 24. a. Place side trims in position by dropping them over the placement screw as seen in Fig. 21 and fitting over the top trim (Fig. 24). Fig. 24 INSTRUCTION SHEET Electrolux TRMKTSS2LV84 Side Trim Installation 25. a. Slide the left Side Trim into place by carefully guiding the Side Trim Attachment slots. Fig. 25 shows an inside view. b. Fasten 2H screws to the top trim (Fig. 26) and repeat for the right hand side. Hand tighten only! Fig. 25 26. a. b. Carefully place the Toe Kick slots over the 4 Leveler Assembly Tabs. The first Leveler Assembly tab is circled in Fig. 27, the second and third tabs are circled in Fig. 28, and the fourth tab is circled in Fig. 29. Adjust the Toe kick until the magnets are engaged to the Leveler Assembly and the Toe Kick is resting vertically in place. Fig. 26 Fig. 27 Fig. 28 Fig. 29 ©2021 Electrolux Home Products, Inc. Instruction Sheet A00343906 9.30.21