Electrolux EI36DD10KS Complete Owner's Guide (English) - Page 12

12 Installation Remove Control Box Cover Remove the cover to the Control Box by removing the Phillips screw as shown and sliding the cover down. Make Blower Electrical Connection and Install Remote Blower - Depending on the type of blower you purchased, refer to its documentation for proper installation instructions. NOTE If you purchased Internal Blower Kit EI06DDPIKS refer to the installation manual provided with the kit for proper installation instructions for this blower - Push wires into wire compartment. - Re-install the control box cover, do not pinch wires when re-installing the cover. Control Box Control Box Cover Phillips Screw Remote Blower Wire Connection Terminal Block Romex Clamp Blower Motor Wiring (Romex or conduit) Ground (Green) Line (Black) Neutral (White) Line Neutral Ground Wire Nuts (3) Downdraft Vent Control Box Blower Wire Connection NOTE The wire nuts supplied with the unit are made for 14 AWG wire. The installer must supply correct wire nuts if a different wire size is used. Romex Cable or Wiring in Metal Conduit Line (Black) Ground Neutral (Green/Bare) (White) Specific to the EI16DDPRKS model