Electrolux EW23CS75QS Complete Owner's Guide (English) - Page 12
Against, Freezer, Drawer, Grab Drawer, At Center, Both Sides, Pull Drawer
View all Electrolux EW23CS75QS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
12 Removing the Doors Installing Freezer Drawer 1 With lower slides pulled out, hang drawer onto slide brackets ensuring pins on each side are fully inserted into slots on each side. Assembly Pin Fully Extend Drawer Slides Cabinet Slot 2 Reinstall four drawer screws (two per side), tighten down, and close drawer (C). Push Against Freezer Drawer A Grab Drawer At Center From Both Sides Then Pull Drawer Out B 6 Tighten four drawer screws. 7 Recheck gasket seal. 8 Install the toe grille by fitting into place. Install Hex Head Drawer Screws 3 Check gasket seal around top, bottom, and sides of freezer drawer. 4 If gasket is not sealed, open drawer and slightly loosen four drawer screws (two on each side) to allow drawer to rotate. 5 Close drawer and recheck the seal on the gasket (A). Open the drawer grabbing by the sides in the center (B). Be careful not to rotate the drawer.