Electrolux Induction/2 Use and Care Guide - Page 18
Setting Surface Controls - ranges
View all Electrolux Induction/2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
1 Setting Surface Controls USINGTHE TOUCH CONTROL The recommended way to use the touch pads on the cooktop is shown in Fig. 1, Be sure that your finger is placed in the center of the touch pad as shown. If the finger is not placed on the center of a pad, the cooktop may not respond to the selection made. Lightly contact the pad with the flat part of your entire fingertip, Do not just use the narrow end of your fingertip, Fig. 1 OPE TING THE SINGLESURFACE DIANT ELEMENT The cooktop has a single radiant surface element at the position shown on Figs. 2 & 3. To Operate the Single Surface Element Fig. 2 Fig. 3 1. Place correctly sized cookware on the radiant surface element. 2. Touch and hold the 0 key pad until a beep sounds. The power indicator light power above the (_ will turn ON. Note: If no other key pad is touched within 20 PowEr seconds the request to Power ON the cooktop will clear, 3. Touch and hold the [] pad for the desired element position until a beep is On,O_F heard. The display wil! show "0.0". Note: If no further pads are touched within 10 seconds the request to power the element ON will clear. 4. Touch hi + pad once to turn ON the power level to HI or touch = Io pad once for power level to Lo, 5. Each touch of the hi + or - Io pad will increase or decrease the power level. Lo is the lowest power level available. Note: The power level may be adjusted at any time while the element is ON. 6. When cooking has been completed touch the [] pad once to turn the O_.eFF element OFF and if no other surface element is used touch the (D key pad to turn off power the cooktop. Each surface element provides a constant amount of heat at each setting, A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area. Note: The Hot Element (HE) message will be showed on display for each element until the heating surface area has cooled sufficiently. CAUTI@N Radiant surfaceelementsmay appear to have cooled after they have been turned OFF.The Hot Element (HE)messagewill be showed and will continue to display until the glass cooktop has cooJeddown to a moderate level.The glass surface may still be hot and burns may occur if the glass surface is touched before the display has turned OFF. Donot place plasticitemssuchas saltand peppershakerss, poon holders or plasticwrappings ontop of the range when it isin use.Theseitemscouldmeltor ignite.Potholderst,owelsor woodenspoonscouldcatchfire ifplacedtoocloseto thesurfaceelements.