Electrolux RH36WC40GS Complete Owner's Guide (English) - Page 12

12 Installing the hood Step 15 WIRING THE HOOD Electrical Shock Hazard Warning: Turn off power at the service panel before wiring this unit. 120 VAC, 15 or 20 Amp circuit required. ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN/YELLOW) SERVES TO GROUND THE APPLIANCE. TO PROTECT YOU AGAINST ELECTRIC SHOCK, THE GREEN AND YELLOW WIRE MUST BE CONNECTED TO THE GROUNDING WIRE IN YOUR HOME ELECTRICAL SYSTEM, AND IT MUST UNDER NO CIRCUMSTANCES BE CUT OR REMOVED. Failure to do so can result in death or electrical shock. • If not already done, install 1/2" conduit connector in j-box. • Run black (live), white (neutral), and green (earth) wires (#14 AWG) according to the National Electrical Code or CSA Standards and local codes and ordinances in 1/2" conduit from power supply to j-box. • Connect black, white, and green wires from power supply to black, white, and green/yellow wires in j-box respectively. • These connections should be done always making reference to the electrical diagram found inside the hood. • Close j-box cover. Step 16 Final installation steps Replace filters and install the lamps as described in the Care & Use section of this manual. Note: Lamps are not supplied, use ONLY 120 Volt, 50 Watt (maximum) 50° halogen light made for a GU10 base, suitable for use in open luminarie. Turn power on at service panel. Check operation of the hood. IMPORTANT: If the hood doesn't switch ON, before calling for service, check if the internal General ON/ OFF Pushb-utton Switch is switched ON. General ON/OFF Push button Switch Back side of the hood Front side of the hood