Emerson LF501EM6F Owner s Manual - Page 23

Setup Before you begin: Make sure the Unit is connected to Antenna or Cable. 1 Press MENU and use H I to select Setup, then press OK. Picture Sound Setup Features Language USB Autoprogram Channel list Add channels Antenna 2 Adjust the following items. Autoprogram Be sure the RF cable is correctly connected to this Unit and you are registered with your Cable TV provider when you Install Cable channels. 1 Use H I to Select Autoprogram, then press OK. ● If you run Autoprogram when you have Locked Channels, a Message appears asking to enter your PIN. Enter your Child Lock PIN in order to Complete the Installation. (Default PIN code is 0, 0, 0, 0.) You need to reset or set the Channel Lock again after the 2 Installation. Use H I to Select an appropriate Option, then press OK. - When Antenna is selected, the TV Detects Any Off-the-Air Antenna Signals. It searches for ATSC (Digital) and NTSC (Analog) Channels available in your Area. - When Cable is selected, the TV detects signals supplied by Cable. It searches for DTV, Analog TV and Cable channels available in your area. Picture Sound Setup Features Language USB Auto program will rescan all channels. Auto programming may take more than 20 minutes to complete. Select your signal source. Antenna Back Antenna Cable Cable Or ANTENNA IN 23 .English Autoprogram Please wait while the system is scanning for channels. Auto programming may take more than 20 minutes to complete. 75% Digital channels Analog channels 10 ch 6 ch Exit ● When the Scanning and Memorizing of Available Channels is Completed, the Lowest Memorized Channel will be Displayed. Note(s) ● After setting Autoprogram, using CH + / - skips unavailable channels Automatically. ● If you are not receiving a signal from your Cable service, contact the Cable provider. ● If you press B or MENU during Autoprogram, the Setup of TV channels will be Cancelled. ● Even if Autoprogram is completed, the channel setting will be lost if the AC Power Cord is unplugged before the Unit goes into Standby mode by pressing B. ● The PIN Code will be required Once you set a PIN code in the Child and Ratings Lock. L p. 26 ● If you want to change your PIN code, follow the instruction for Change PIN. L p. 28 Channel list The channels selected here can be skipped when selecting the channels using CH + / -. Those channels can still be selected with the NUMBER keys. 1 Use H I to select Channel list, then press OK. 2 Use H I to select the channel you want to remove, then press OK. Picture Sound Setup Features Language USB Highlight channels for Ch Up/Down key selection. DTV DTV DTV 11.1 11.2 11.3 Ch Select Watch / Skip Back ● The channel display for the removed channel darkens. You will not be able to select the channel again using CH + / -. ● To reactivate a removed channel, use H I and press OK. The registered channels are highlighted. ● When you remove a main channel, its subchannels are removed as well. Note(s) ● The channel with DTV indicated on the display is ATSC. Otherwise the channel is Analog TV (NTSC). Continued on next page.