Epic Fitness 400 Mx User Manual - Page 7

2. Insert the excess Wire Harnesses (22, 108) into the right Upright (99). Set the console assembly on the Uprights (99). While a second person holds the console assembly, attach the console assembly with four Console Bolts (86) and four Console Washers (88) as shown. Start all four Console Bolts before firmly tightening them. 2 Console Assembly 22, 108 88 88 86 86 99 3. Insert a Wheel (93) into a Wheel Housing (43). Attach the Wheel with a Wheel Bolt (92) and a Nut (25). Note: Do not overtighten the Nut. The Wheel should be able to spin freely. Tip the Uprights (99) forward slightly and insert a Wheel Housing (43) into the base of the Uprights as shown. Attach the other Wheel and Wheel Housing as described above (not shown). 3 99 25 43 93 92 4. With the help of a second person, carefully lower the Uprights (99). Make sure that the Wheel Housings (43) 4 remain in the base of the Uprights. 99 Attach each Wheel Housing (43) with a 1" Tek Screw (98). Attach two Base Pads (97) to the bottom on each side of the Upright (99) with 1" Tek Screws. With the help of a second person, carefully raise the Uprights (99) to the vertical position. 98 43 7