Epic Fitness 400 Mx User Manual - Page 8
Orient the receiver so the small cylin
View all Epic Fitness 400 Mx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Press the Latch Sleeve (89) into the left Upright (99). 5 Note: It may be helpful to use a rubber mallet to fully in- sert the Latch Sleeve. Remove the latch knob from the latch pin. Make sure that the latch pin collar and the spring are on the latch pin. (Note: If there are two latch pin collars, place one on each side of the spring.) Insert the latch pin into the left Upright (99), and tighten the latch knob onto the latch pin. Knob 89 Spring 99 Collar Pin 6. Remove the backing from the indicated tape on the console assembly. Press the Book Holder (62) firmly onto the tape. Note: The Book Holder may be preassembled. 6 Console Assembly 62 Tape 7. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the treadmill to protect the floor or carpet. For your benefit, we recommend that you familiarize yourself with the TROUBLESHOOTING section on pages 27 and 28. If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver included with the chest pulse sensor. 1. Make sure that the power cord is unplugged. Remove the indicated Screw (2) and the Access Door (95). 2. Remove the paper from the adhesive pad on the back of the receiver (A). Orient the receiver so the small cylinder is near the lower edge of the receiver and is facing the Console Back (85) as shown. Firmly press the receiver onto the indicated corner of the Access Door (95). Connect the wire on the receiver to the Pulse Wire (111) extending from the Console Back. 3. Make sure that no wires are pinched. Reattach the Access Door (95) with the Screw (2). Note: The other wires included with the receiver may be discarded. 111 A Cylinder 85 95 2 8