Epic Fitness El 2980 Elliptical English Manual - Page 7

3. Attach the Track Frame (4) to the Frame (1) with two M10 x 25mm Patch Screws (48) and two 3 M10 Split Washers (85). Tip: Finger tighten an M10 x 25mm Patch Screw (48) into the lower hole first, and then finger tighten a Patch Screw into the upper hole. Then, tighten both Patch Screws. Tip: This step may be easier if you raise the Frame (1) a few inches in the location shown by the arrow at the right while you attach the Track Frame (4). See the inset drawing. Tighten two Leveling Feet (36) into the underside of the Track Frame (4). 1 85 48 85 48 4 4 36 4. Apply a small amount of the included grease to the sides of two Wave Washers (78) and to two 4 Thrust Washers (66). Slide a Weld Spacer (68) onto the left Crank Arm (37). Next, identify the Left Track Arm (12), which is marked with a "Left" sticker. Orient the Left Track Arm (12) as shown, and 37 slide it onto the left Crank Arm (37). Then, slide a Wave Washer (78) on the end of the left Crank Arm. Grease 11 68 Slide an M8 Small Washer (18) and an Axle Cap (41) onto an M8 x 19mm Button Screw (56). Next, slide a Thrust Washer (66) onto the shoulder of the Axle Cap. 78 66 56 18 41 12 Then, tighten the M8 x 19mm Button Screw (56) into the end of the left Crank Arm (37). Make sure that the Thrust Washer (66) remains on the shoulder of the Axle Cap (41), and that the Wave Washer (78) remains on the end of the left Crank Arm. Repeat this step to attach the Right Track Arm (11). 7