Epson 2090 User Manual - Page 31

Using the Micro Adjust Function, Adjusting the tear-off position

Get Epson 2090 - LQ B/W Dot-matrix Printer PDF manuals and user guides
UPC - 010343850064
View all Epson 2090 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

To load a single card, follow the instructions in "Loading Single Sheets with the Paper Guide" on page 26. To load multiple cards, see the Reference Guide. Note: ❏ When you are loading postcards long edge first, always load them in the top slot. ❏ When loading A6 size cards, always load them long edge first. ❏ Before printing, turn on the card mode by pressing the Tear Off/Bin button several times until the left Tear Off/Bin light is on. Using the Micro Adjust Function The Micro Adjust function allows you to move the paper forward or backward in 1/180-inch (0.141 mm) increments to adjust the tear-off and top-of-form positions. Adjusting the tear-off position If your paper's perforation is not aligned with the tear-off edge, you can use the Micro Adjust function to move the perforation to the tear-off position, as described below. Your tear-off position setting remains in effect until you change it, even if you turn off the printer. c Caution: Never use the knob to adjust the tear-off position; this may damage the printer or cause it to lose the tear-off position. Paper Handling 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Paper Handling
31
To load a single card, follow the
instructions in “Loading Single
Sheets with the Paper Guide” on
page 26. To load multiple cards,
see the
Reference Guide
.
Note:
When you are loading
postcards long edge first,
always load them in the top
slot.
When loading A6 size cards,
always load them long edge
first.
Before printing, turn on the card mode by pressing the
Tear Off/Bin
button several times until the left Tear Off/Bin light is on.
Using the Micro Adjust Function
The Micro Adjust function allows you to move the paper forward or
backward in 1/180-inch (0.141 mm) increments to adjust the tear-off and
top-of-form positions.
Adjusting the tear-off position
If your paper’s perforation is not aligned with the tear-off edge, you can
use the Micro Adjust function to move the perforation to the tear-off
position, as described below. Your tear-off position setting remains in
effect until you change it, even if you turn off the printer.
c
Caution:
Never use the knob to adjust the tear-off position; this may damage the
printer or cause it to lose the tear-off position.