Epson 2190 Product Information Guide - Page 5

EPSON FX-890/FX-2190 Environmental Temperature Operation (plain 41 to 95 °F (5 to 35 °C) paper) Operation 59 to 77 °F (15 to 25 °C) (recycled paper, envelopes, labels or roll paper) Storage -22 to 140 °F (-30 to 60 °C) Humidity (without condensation) 10 to 80% RH 30 to 60% RH 0 to 85% RH Paper Use recycled paper, multipart paper, labels, envelopes, and roll paper only under normal temperature and humidity conditions, as follows: Temperature Humidity 59 to 77 °F (15 to 25 °C) 30 to 60% RH Do not load paper that has been folded or is damaged, wrinkled, or curled. Single sheets, front or rear entry Width* (inch) (mm) Length** (inch) (mm) Thickness*** (inch) (mm) Weight (lb) (g/m²) Quality Minimum 3.9 100 Maximum FX-890: 10.1 257 3.9 14.3 100 364 0.0025 0.065 0.0055 0.14 14 24 52 90 Plain paper and recycled paper FX-2190: 16.5 420 * 7.2 to 8.5 inches (182 to 216 mm) using the optional cut-sheet feeder for FX-890. 7.2 to 16.5 inches (182 to 420 mm) using the optional cut-sheet feeder for FX-2190. ** 8.3 to 14.3 inches (210 to 364 mm) using the optional cut-sheet feeder. ***0.0028 to 0.0055 inch (0.07 to 0.14 mm) using the optional cut-sheet feeder. Single-sheet multipart forms (for the optional front sheet or front paper guide only): Minimum Maximum Width (inch) (mm) FX-890: FX-2190: 3.9 10.1 16.5 100 257 420 Length ((inch) (mm) 3.9 14.3 16.5 100 364 420 Copies 1 original + 5 copies Total thickness (inch) (mm) 0.0047 0.12 0.018 0.46 Weight per sheet of multipart (lb) 12 15 (g/m²) 40 58 Quality Carbonless multipart forms with a line of glue at the top or one side of the form Continuous paper (ordinary and multipart): Minimum Maximum Width (inch) (mm) 4.0 101.6 FX-890: 10.0 254.0 FX-2190: 16.0 406.4 Length, one page (inch) (mm) 4.0 101.6 22.0 558.8 Copies 1 original + 5 copies Total thickness (inch) (mm) 0.0025 0.065 0.018 0.46 Weight, ordinary paper (lb) 14 22 (g/m²) 52 82 Weight per sheet of multipart (lb) 12 15 (g/m²) 40 58 Quality Plain paper, recycled paper, and carbonless multipart forms with point gluing or paper stapling on both sides Do not load thick paper, such as multipart forms with five or six parts, in the rear slot. The ratio of the cut/uncut length at the perforation should be between 3:1 and 5:1. The thickness of the perforation part when extended should be 1 mm or less. The perforation between pages should not extend all the way to the edges of the paper. Uncut length on the edges should be 1 mm or more. The horizontal and vertical perforation cuts should not cross. 4 - EPSON FX-890/FX-2190 6/03