Epson 5040UBe Quick Setup - Page 1

PowerLite® Home Cinema 5040UB/5040UBe Quick Setup Before using the projector, make sure you read the safety instructions in the online User's Guide. Choose a location Keep the projector level and place it at a height so its lens is even with the top or bottom of the screen and is centered horizontally. If this isn't possible, use the lens shift feature or the keystone correction button on the projector to reposition the image (see "Adjust the image"). In order to view 3D images correctly, RF 3D glasses must be worn within 32 feet (10 m) of the projector. Use the image below to determine the viewing distance for 3D projection (the shading represents the 3D viewing area): WirelessHD™ Transmitter (PowerLite Home Cinema 5040UBe only) Follow these steps to set up the included WirelessHD Transmitter. HDMI 1 Place the transmitter within 32 feet (10 m) of the projector. Make sure the front of the transmitter faces the front of the projector. See the online User's Guide for more information on the WirelessHD transmission range. 32 ft (10 m) 16 ft (5 m) 16 ft (5 m) 32 ft (10 m) See the online User's Guide for more information on where to place your projector. Connect the projector Choose from the following connections. For additional connection types, see the online User's Guide. Video device 1 If necessary, remove the cover as shown below. Note: Do not place the transmitter on a metal surface, as this may interfere with the signal. Make sure there are no obstructions between the transmitter and the projector. 2 Plug the AC adapter into the transmitter and a wall outlet. 3 Connect the HDMI cables to your video input devices and the HDMI ports on the side and back of the transmitter. You can connect up to four input devices to the transmitter. See "Viewing WirelessHD content" on the back of this sheet for information on switching between input sources. 2 Connect multiple video devices and use the Source buttons on the remote control or the button on the projector to switch between them. HDMI cable Optical HDMI Note: When connecting a source that requires HDCP 2.2, you must use the HDMI1 port. Note: You can connect tablets, smartphones, and other devices that support the MHL™ standard to the HDMI port on the side of the WirelessHD Transmitter. Some devices may require an adapter or may not require an MHL cable. Not all features or functions may be supported. Check your device's documentation for more information. 4 To use the transmitter as a pass-through device to a television or other display, connect an HDMI cable to the display device and the HDMI output port on the rear of the transmitter. See "Viewing WirelessHD content" on the back of this sheet for information on switching between wireless and wired display modes.