Epson 5040UBe Quick Setup - Page 3

4 Press the Lens button on the remote control again and use the and buttons to reduce or enlarge the image. Note: If the glasses don't automatically display 3D content, you may need to pair them with the projector. Move the glasses within 10 feet (3 m) of the projector, then press and hold the Pairing button on the 3D glasses for at least 3 seconds. The status light on the glasses will alternately flash green and red, then remain green for 10 seconds if pairing is successful. 5 Press the Lens button on the remote control again and use the , , , and buttons to reposition the image. 6 If your image looks like or , you can use the buttons on the projector to correct this. Note: Using the keystone adjustment can affect the size and effective resolution of your image. If possible, change the position of your projector to eliminate the keystone effect and use the lens shift option to position the image as necessary. 7 Press Esc to exit. Viewing 3D images To view 3D content, you must first connect a 3D-compatible video device to one of the HDMI ports on your projector. You also need a pair of Epson® (part number V12H548006) or Epson-compatible RF 3D active shutter glasses. 1 Turn on and begin playback on the 3D-compatible video device. Note: Make sure you set the video device to play content in 3D mode. 2 Slide the power switch on your 3D glasses to the On position. You can also automatically convert 2D HDMI content to 3D. To enable the 2D-to-3D Conversion option, press the Menu button on the projector or remote control. Select Signal and press Enter, then select 3D Setup and press Enter. Select 2D-to-3D Conversion and press Enter. Select the Weak, Medium, or Strong setting, then press Enter. See the online User's Guide for more information on adjusting 3D images. Viewing WirelessHD content (PowerLite Home Cinema 5040UBe only) 1 Turn on your video device and begin playback. 2 Turn on the power switch on the side of the WirelessHD Transmitter. 3 Turn on the projector. 4 If you have connected a television or other display to the output port on the transmitter and want to switch between wired and wireless display modes, press the Output button on the remote control or the WiHD/Pass button on the transmitter. The WiHD light on the transmitter lights up when the wireless display mode is active. 5 Press the WirelessHD button on the projector remote control. Note: If the WirelessHD connection fails, see the "Troubleshooting" section. 6 If you have connected multiple input devices to the transmitter, press the Input button on the remote control or transmitter once to display the sub-screen menu, then press the button again to switch between the input devices. See the online User's Guide for more information on adjusting and configuring the WirelessHD connection and display modes.