Epson 7700p Product Information Guide - Page 10

EPSON PowerLite 7700p Projector 4. If you need to replace the filter, remove it as shown below. Make sure the projector is on its side as shown (not turned upside down) to prevent dust from falling inside. Follow these steps to replace the lamp: 1. Turn off the projector and unplug the power cord. 2. Allow the projector to cool down for at least an hour (if it has been on). 3. Use a screwdriver to loosen the screw on the lamp cover. (You can't remove the screw from the cover.) When the screw is loose, slide off the lamp cover. 5. To install the new filter, first insert the tabs, then press on the catch until it clicks in place. 4. Use a screwdriver to loosen the two screws holding the lamp in place. (You can't remove these screws.) 5. Lift up the wire handle, as shown, and pull the lamp straight out. (The plastic flap above the lamp will flex out of the way as you remove the lamp.) tabs handle Replacing the Lamp The projection lamp typically lasts for about 1500 hours of use. It is time to replace the lamp when: t The projection image gets darker or starts to deteriorate. t The lamp warning light is flashing red or orange. t The message LAMP REPLACE appears on the screen when the projector lamp comes on (after about 1400 hours of use). To maintain projector brightness and image quality, replace the lamp as soon as possible. Note: You can check to see how many hours the lamp has been used through the About menu. Contact your dealer or call EPSON at (800) 873-7766 in the United States and Canada for a replacement lamp. Request part number ELPLP12. 6. Fully insert the new lamp. (The plastic flap will flex out of the way.) Caution: Do not touch the glass portion of the lamp assembly. 7. Once the lamp is fully inserted, tighten its screws. 10 - EPSON PowerLite 7700p Projector 11/00