Epson BrightLink Solo Interactive Module IU-01 Quick Setup Guide - Page 11

Confirming the Projector Position, The distance from the wall to the top of the projector's lens

Get Epson BrightLink Solo Interactive Module IU-01 PDF manuals and user guides View all Epson BrightLink Solo Interactive Module IU-01 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

English Confirming the Projector Position Once you have determined where to install the interactive module, you can determine whether the projector's position needs to be adjusted to avoid possible interference. AVOID Projector You can mount the interactive module and then test the installation with your projector turned on. Or, you can follow the steps below to calculate whether your projector's position needs to be adjusted. 1 Measure the following projector distances: • The distance from top of the projection area to the top edge of the projector's lens (a) • The distance from the wall to the top of the projector's lens (c) Arm length is 41.73 inches (1060 mm) 2 Make sure the distance from the top of the projector lens to the top of the image (a) is less than: (b -5.9 inches) × c/41.73 inches or (b -150 mm) × c/1060 mm If the distance from the top of the projector lens to the top of the image (a) is less than the calculated value, the interactive module can be used without adjusting the projector position. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
11
English
Confirming the Projector Position
Once you have determined where to install the interactive module, you can determine whether the
projector’s position needs to be adjusted to avoid possible interference.
You can mount the interactive module and then test the installation with your projector turned on. Or, you
can follow the steps below to calculate whether your projector’s position needs to be adjusted.
1
Measure the following projector distances:
•
The distance from top of the projection area to the top edge of the projector’s lens (
a
)
•
The distance from the wall to the top of the projector’s lens (
c
)
2
Make sure the distance from the top of the projector lens to the top of the image (
a
) is less than:
(
b
–5.9 inches) ×
c
/41.73 inches
or (
b
–150 mm) ×
c
/1060 mm
If the distance from the top of the projector lens to the top of the image (
a
) is less than the calculated
value, the interactive module can be used without adjusting the projector position.
AVOID
Projector
Arm length is 41.73 inches (1060 mm)