Epson ColorWorks C7500 ESC/label Command Reference Guide - Page 31
Print area settings using ZPL II commands
View all Epson ColorWorks C7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
2.4.7 Print area settings using ZPL II commands ZPL II commands can be used to change some print area settings. These ZPL II commands and the corresponding print area settings are shown in Table 2.4.5. ZPL II command ^LT ^PW Table 2.4.5 ZPL II Commands for Setting the Print Area Function Print area setting Sets the vertical printing position adjustment. Adjustment of leading edge position of label Sets the label width Label width + left gap (mount) Paper Next label Maximum printable area Printable area Left gap Label width Adjustment of leading edge position of label (^LT) Label width specified with ^PW Figure 2.4.8 ZPL II Commands for Setting the Print Area The ^PW command specifies the sum of the left gap (mount) and label width. When the label width is specified with ^PW, the left gap is fixed and cannot be changed, and the value specified by ^PW minus the current left gap is set as the label width. ESC/Label Command Reference Guide Rev. E Page 31