Epson ELP-5500 Product Information Guide - Page 6

EPSON PowerLite 5500C/7500C Multimedia Projector 4. The air filter is attached to the inside of the filter cover. It is recommended that you use a small vacuum cleaner designed for computers or other office equipment to clean the filter. If you don’t have one, use a dry, lint-free cloth. If the dirt is difficult to remove or if the filter is torn, replace the air filter. Note: An air filter comes with each replacement lamp. 5. Place the air filter back inside the filter cover. 6. Plug the power cable back into the electrical outlet. 4. Use a screwdriver, coin, or similar object to loosen the two screws holding the lamp unit in position. (You cannot remove these screws.) Replacing the Lamp The projector lamp typically lasts for about 2000 hours of use. It is time to replace the lamp when: t The projected image gets darker or starts to deteriorate t The projector lamp indicator is red or is flashing orange and red alternately t The message LAMP REPLACE appears on the screen when the projector lamp comes on Warning: Let the lamp cool before replacing it. Also, do not touch the glass portion of the lamp assembly; this can cause premature lamp failure. 1. Turn off the projector and unplug the power cable from the electrical outlet and the projector. Wait at least 20 minutes for the bulb to cool. 2. Place the projector on its side with the handle at the top so the lamp cover is easily accessible. 3. Use a screwdriver, coin, or similar object to loosen the retaining screw on the lamp cover. When the screw is loose, lift off the lamp cover. (You cannot remove this screw from the cover.) 2 2 1 Caution: Do not touch the glass portion of the lamp assembly; this can cause premature lamp failure. 5. Lift up the handle and pull out the lamp assembly. 6. Gently insert the new lamp assembly by lowering it into position. Make sure it’s inserted securely. Tighten the screws on the new lamp assembly. 7. Replace the lamp cover and tighten the cover screw. (Make sure the lamp cover is securely fastened. The projector will not run if the lamp cover is open.) Optional Accessories The following optional accessories are available for the projector. To order, call EPSON Accessories at (800) 873-7766. Accessory Spare lamp and filter Soft travel case for projector and laptop Hard travel case Computer cable ELP Link III set for PC (includes software and cables) ELP Link III set for Mac (includes software and cables) Mac adapter set Portable screen Part number ELPLP06 ELPKS13 ELPKS14 ELPKC02 ELPSW03 ELPSW04 ELPAP01 ELPSC06 1 6 - PowerLite 5500C/7500C Multimedia Projector 2/99