Epson EMP 70 Instruction Manual - Page 61

Problem and Alarm Display Indicator Indicator Status Steady red Flashing red (1-second intervals) Flashing red (2-second intervals) Flashing orange Cause Remedy or Status High The usage temperature range of the projector is internal 5°C-35°C, and the projector should be used in this temperature range. Place the projector in a well-ventilated location where air intake and exhaust vents are not blocked. Clean the air intake vent. While the indicator is red, turn off the lamp to lower the internal temperature of the projector. Problem with lamp Replace with new lamp. Model No: ELPLP13 If the lamp is broken, handle pieces carefully to avoid injury, and consult an Epson Service Center for repair (video cannot be projected until the lamp is replaced). If the lamp or lamp cover is not attached securely, follow the replacement instructions to attach it securely. Internal problem Stop using the projector, pull the plug from the outlet, and consult your vendor or an Epson Service Center (listed at the end of this manual) for repair. High-speed cooling in progress Not a problem, but projection will be interrupted automatically to prevent further temperature rise. The usage temperature range of the projector is 5°C-35°C, and the projector should be used in this range. Place the projector in a well-ventilated location where air intake and exhaust vents are not blocked. Clean the air intake vent. See Page 77 18 67 68 - 68 - 77 18 67 Point: • If the indicator is normal but you experience problems with video projection, refer to "When Indicators Do Not Help" on the following page. • If the indicator display status is not shown in this table, consult your vendor. 59