Epson EMP-82e User Guide - Page 46
Problems when projection starts, Other problems, Check, Remedy
View all Epson EMP-82e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Problem Solving 46 f Problems when projection starts f Power does not turn on Check Did you press the [Power] button? Are the indicators switched off? Do the indicators turn on and off when the power cable is touched? Is the operation lock set to "Full Lock"? Is the correct setting for the remote receiver selected? (EMP-83/822 only) Was the power cable plugged back in immediately after Direct Power Off, or is the breaker turned off? (EMP-83/822 only) Remedy Press the [Power] button to turn the power on. The power cable is not connected correctly or power is not being supplied normally. Connect the projector's power cable correctly. s Quick Start Guide Check that your electrical outlet or power source is functioning correctly. There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address provided in the International Warranty Terms. sInquiries When you press and hold down the [Enter] button on the control panel for about seven seconds, a message is displayed and the lock is released. s p.20 Check the "Remote Receiver" in the configuration menu. s"Settings"-"Remote receiver" p.28 When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn back on. Press the [Power] button to turn the power back on. f Other problems f There is no audio or the audio is too low Check Is the audio source connected correctly? Is the volume adjusted to the minimum setting? Is A/V Mute active? Is the audio cable's specification "No resistance"? Remedy Check that the cable is connected to the Audio port. Adjust the volume so that sound can be heard. s Quick Start Guide Press the [A/V Mute] button on the remote control to cancel A/V Mute. s p.15 When using a commercially available audio cable, make sure it is labelled "No resistance".