Epson EMP-82e User Guide - Page 47
Check, Remedy, The remote control does not work
View all Epson EMP-82e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Problem Solving 47 f The remote control does not work Check Is the remote control light-emitting area pointing towards the remote receiver on the projector when it is operated? Is the remote control too far from the projector? Is direct sunlight or strong light from fluorescent lamps shining onto the remote receiver? Is the correct setting for the remote receiver selected? (EMP-83/822 only) Are the batteries dead or have the batteries been inserted correctly? Was a remote control button pressed for more than 30 seconds? Remedy Point the remote control towards the remote receiver. The operating angle for the remote control is about 30 horizontally, and about 15 vertically. s Quick Start Guide The operating range for the remote control is about 6 m. s Quick Start Guide Set the projector up in a location where strong light does not shine onto the remote receiver. For EMP-83/ 822, set the remote receiver to "Off" from "Remote Receiver" in the configuration menu. s"Settings""Remote receiver" p.28 Check the "Remote Receiver" in the configuration menu. s"Settings"-"Remote receiver" p.28 Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s p.51 If any of the buttons on the remote control are pressed down for more than 30 seconds, the remote control stops sending signals (remote control's sleep mode). When the button is released, normal remote control operation resumes. This can prevent the batteries from running down accidentally because Sleep Mode operates when the remote control is stored in a bag or if an object is placed on top of it. f Mail is not received even if a problem occurs with the projector (EMP-83/822 Only) Check Is "Standby Mode" set to "Network On"? Did a fatal problem occur and the projector come to a sudden stop? Is power being supplied to the projector? Is the LAN cable connected correctly? Is "Mail" set correctly in the configuration menu? Remedy To use the Mail Notification function when the projector is in standby, set "Network On" from "Standby Mode" in the configuration menu. s"Extended"-"Standby Mode" p.29 When the projector comes to a sudden stop, mail cannot be sent. If the problem continues, contact your local dealer or the nearest address provided in the International Warranty Terms. sInquiries Check that your electrical outlet or power source is functioning correctly. Check that the LAN cable is connected correctly. Reconnect it if it is not connected or it is not connected correctly. s p.62 Mail notification of problems is sent according to the "Mail" settings in the configuration menu. Check if it is set correctly. s"Network Menu"-"Mail Menu" p.32