Epson ES-300C Product Support Bulletin(s) - Page 17
PSB No: P-0077, EPL-7000 cont., MAIN MOTOR ERROR, ES300C Display Codes, GQ-3500 Display Codes
View all Epson ES-300C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
PSB No: P-0077 Page: 9 of 11 EPL-7000 cont. [S] WARMING UP The printer is warming up. Note: If any of the following messages appear, turn the printer off for at least five seconds, then turn it back on. If the same message is displayed, repair is required. SCAN MOTOR ERROR HSYNC ERROR HEATER LAMP ERROR MAIN MOTOR ERROR FAN MOTOR ERROR ES300C Display Codes E-C Command error. An unidentified command or parameter was detected. E-l Interface error a. Incorrect communication parameter received. b. Broken connector or wire. c. Host failed to respond within 30 seconds. d. Host is not accepting data. (DSR= Low) E-F Fatal error a. A lamp is broken. b. Power is applied before the transportation screws were removed. c. System failure GQ-3500 Display Codes do Cover Open error EO-00 Engine driver CPU error. EO-01 Option tray CPU error. EO4+02 Option tray motor error.