Epson ET-2400 Users Guide - Page 162
Resetting Network Settings, Solving Setup Problems, Product Does Not Turn On or Off
View all Epson ET-2400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
Uninstall Your Product Software Power Cleaning Resetting Network Settings You can reset the network settings to their factory defaults. 1. Turn off your product. 2. Hold down the network status button and press the power button until the Wi-Fi light and Wi-Fi Direct light flash alternately. Then release both buttons. When the Wi-Fi light and Wi-Fi Direct light turn off, the Wi-Fi settings are reset. Parent topic: Solving Problems Solving Setup Problems Check these sections if you have problems while setting up your product. Product Does Not Turn On or Off Noise After Filling the Ink Software Installation Problems Parent topic: Solving Problems Product Does Not Turn On or Off If you cannot turn the product on or off, try these solutions: • If you cannot turn on your product, make sure the power cord is securely connected and hold down the power button a little longer. • If you cannot turn off your product, hold down the power button a little longer. If you still cannot turn off your product, unplug the power cord, plug the power cord back in, then turn your product on and off again using the power button. Parent topic: Solving Setup Problems Noise After Filling the Ink If you hear noises from your product after filling the ink tanks with ink, check these explanations: • The first time you fill the tanks with ink, the product must charge its print head. Wait until charging finishes before you turn off the product, or it may charge improperly and use excess ink the next time you turn it on. Your product is finished charging the print head when the power light stops flashing. 162