Epson ET-3700 Users Guide - Page 166

LCD screen message Condition/solution Combination of IP address and subnet mask is invalid. See your documentation. There is a problem with the network connection to your product. Check the solutions in this guide. Check that the printer driver is installed on the computer and that the port settings for the printer are correct. Make sure the printer port is selected correctly on the Port tab of the Printer Properties screen (Windows) or the System Properties > USB list (Mac). Select USBXXX for a USB connection or EpsonNet Print Port for a network connection. Check that the printer driver is installed on the computer and that the USB port settings for the printer are correct. Recovery mode An error has occurred during firmware updating. Connect your product using a USB cable and try updating the firmware again. If you still receive this error message, contact Epson for support. Note: The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages. During the life of your product it may reach a condition where either satisfactory print quality cannot be maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your LCD screen, or lights on the control panel will advise you when these parts need replacing. If this happens during the standard warranty of the product, the exchange of the product or replacement of the pads is covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any Epson authorized service provider. The waste ink pads are not a user-replaceable part. Parent topic: Solving Problems Related references Where to Get Help Related tasks Checking for Software Updates Related topics Wi-Fi or Wired Networking Solving Paper Problems 166