Epson Perfection 4490 Photo Product Information Guide - Page 4

Epson Perfection 4490 Photo Scanning a Document or Photo 1. Open the scanner cover. Make sure the document mat is installed inside the cover. If it is not installed, see "Replacing the Document Mat" on page 7 for instructions. 4. Close the scanner cover gently so that your original does not move. 2. Place your document or photo on the document table, face down on the glass. Make sure the top of the document or photo is against the upper right corner of the document table. Note: Always keep the document table clean. Do not leave photos on the document table for an extended period of time as they may stick to the glass. Scanning Film and Slides Removing the Document Mat To scan film strips or slides, you need to remove the document mat from the scanner cover. This uncovers the transparency unit so your scanner can use it to scan your film or slides. 1. Make sure the cover cable is connected to the scanner's OPTION port. 3. If you are scanning multiple photos at once, position each photo at least 20 mm (0.8 inches) apart from the others. Note: If you are scanning large or thick documents, you can remove the scanner cover. Note: Before connecting or disconnecting the cover cable, turn off the scanner using its power switch. 4 - Epson Perfection 4490 Photo 4/05